Run emacs in batch mode to byte-compile elisp files
emacs is my favorite text editor. (No flame please.)
Little known and used perhaps is the fact that emacs does run in batch mode. By batch, I mean emacs accepts and executes commands in the command line, without any user interaction.
You can emulate a typical emacs text editing session as follow:
This command opens the afile.txt in batch emacs mode.
The -l parameter specifies an elisp file to load and execute. In this example, it loads the elisp file named runme.el which modifies the file buffer.
Next, it saves the buffer. Note that the -f parameter tells emacs to run a command, save-buffer in this case.
Finally, the -kill tells emacs to exit.
Below, I run emacs in batch to byte-compile a list of source elisp files. This comes in handy if you have a lot of source elisp files to compile.
Note that I do not need to save the buffer. Hence, no save-buffer.
The output byte-code files (.elc) will be put in the same directory as the source elisp files.
The runme.el file contains the commands to byte-compile the source elisp files.
Little known and used perhaps is the fact that emacs does run in batch mode. By batch, I mean emacs accepts and executes commands in the command line, without any user interaction.
You can emulate a typical emacs text editing session as follow:
$ emacs -batch afile.txt -l runme.el -f save-buffer -kill This command opens the afile.txt in batch emacs mode.
The -l parameter specifies an elisp file to load and execute. In this example, it loads the elisp file named runme.el which modifies the file buffer.
Next, it saves the buffer. Note that the -f parameter tells emacs to run a command, save-buffer in this case.
Finally, the -kill tells emacs to exit.
Below, I run emacs in batch to byte-compile a list of source elisp files. This comes in handy if you have a lot of source elisp files to compile.
$ emacs -batch -l runme.el -kill Note that I do not need to save the buffer. Hence, no save-buffer.
The output byte-code files (.elc) will be put in the same directory as the source elisp files.
The runme.el file contains the commands to byte-compile the source elisp files.
$ cat runme.el
(byte-compile-file "/home/peter/emacs/mods/log4j-mode.el")
(byte-compile-file "/home/peter/emacs/mods/vm-w3m.el")