Triforce 3D Lamp #3DPrinting #3DThursday
G0057Y shared this project on Thingiverse!
This is a 3D Lamp model of the Triforce from Legend of Zelda saga games.
It is designed for 4x 5mm bulb LEDs, but can be used withs smd. Make sure you use the proper circuit to light it up. I used 3v 20mA LEDs, in sets of two, with a 150ohm resistance
Button cap with Hylian Shield Desgin with a 3mmx2mm hole to insert the square button pin.
The hollow yellow pyramids must be glued in position, but it has a 3mm overgrowth so they fit right in.
Brightness depends on the LED you use, but its not a reading lamp, just decorative.
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!
Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!
from Adafruit Industries – Makers, hackers, artists, designers and engineers! http://ift.tt/2v8RnLR
via IFTTT