Super Gamepad Zero: RetroPie in an Original Super Nintendo Controller! #piday #raspberrypi @Raspberry_Pi
Put a whole RetroPie set-up inside a SNES controller! Check out the great walkthrough on Howchoo:
The Super Gamepad Zero connects to your TV using an HDMI cable and normal Micro USB power supply. Just connect it and start playing your favorite retro games! And there you have it: the controller is the system, all-in-one.
For this project, we’ll solder the Raspberry Pi Zero computer to the the original SNES controller’s printed circuit board. Then, we’ll put the Pi into a new 3D-printed bottom housing to give us easy access to the Pi’s HDMI, USB, and port ports.
You can then connect your Super Gamepad Zero directly to a power source and your TV or computer monitor.
Project cost
The total materials for this project cost around $50, including the SNES controller. I already had the tools needed.Project time
It takes about an hour to assemble the controller and install RetroPie. The bottom controller housing took about 6 hours to print on my Ender 3, but of course I was doing other things while it was printing.
Each Friday is PiDay here at Adafruit! Be sure to check out our posts, tutorials and new Raspberry Pi related products. Adafruit has the largest and best selection of Raspberry Pi accessories and all the code & tutorials to get you up and running in no time!
from Adafruit Industries – Makers, hackers, artists, designers and engineers! https://ift.tt/2QN3C7T
via IFTTT
