Lav Mic Clip #3DPrinting #3DThursday
swolebro shared this project on Thingiverse!
A plastic clip for a lavalier microphone (aka. lapel mic) that can be affixed a shirt via a magnet, rather than clipping. This works better for t-shirts where there’s no convenient place to put a standard clip except the collar, which is kinda close to the mouth.
Superglue a small metal shim to the back (eg. a washer; I personally used a spare collar stay) and then use a magnet (or two) on the inside of your shirt. Since there’s no relative motion between the magnets and the wires, you don’t need to worry about signal distortion – I’ve done several videos with this setup and it works great.
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!
Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!